If you need the fridge so its easy access from the rear then this could be the unit for you! The fridge is fitted onto a DSS fridge slide, then the 2 drawers fill the remaining space on the other side (can go either side). This unit is higher so consideration is needed for the amount of space left above – as a guide the top level will finish approx. 90mm higher than the height of your fridge (allowing for material + fridge slide + clearance). Check out the details below for more info – this unit can be customized to suit you so whatever fridge you have and whatever you need…just let me (Beechy) know….
Solid floor/bed to top – full length, full width.
Solid floor/bed to top – full length, full width.
The slide can have an open top box built into the front of it…so when you slide the fridge out you have access to the space behind for storage.
At the front of the unit we normally build in 2 x hatch/box sections – this is because the drawers / fridge don’t use the full length, so the hatch’s make use of this space for storage.
Or alternatively we can do some drop down doors that you access from the front (seats folded forward).
And we can also include a water tank – these 55L poly tanks are very good value (stainless tanks also available).
The slide out table is OPTIONAL, but really it’s a MUST! It can be used when slide half way out as a bench, or even set-up free standing on the ground like shown here!
We can also take care of any 12V work needed – we have a full time autolec on the books here at Drifta – so we’re the one stop shop!
You also have full use of the space around the wheel arch’s with the lift off side wings for easy access.
This particular customer wanted 2 fridges so we made the DSS slide longer with space for both fridges.